Description
Wells Gardner K4600 Series Black Level Control Potentiometer VR201 used on the interface pcb. This replaces the original 1.5K pot 40X0590-017. .25 Watt 350VDC Maximum operating voltage 20% tolerance. 2.5K pot that will fit the board perfectly and can be mounted on either side to make adjusting it easier and safer. This pot will work on all the versions of interface boards for the K4600 & K4700 P297, P298, P302, P305, P305, P306, P307, P308, and P317. If you have a P317 PCB you may need the vertical mount version of this pot which is the P1027 in our trimmer potentiometer category.
delusional29 (verified owner) –
These work great on the interface boards on my k4600 monitors. I solder them on the opposite side to have easier access to the black level pot while the monitor is on. No issues.
Jared Bresee (verified owner) –
What can I say, this is top-notch I love putting this on the boards because it just makes everything easier when working with your K 4600. It may not be necessary but once you put it on you’ll understand if you can make life a lot easier 🙂
Anna (verified owner) –
a good addition when getting the k4600 cap kit.
AlexZander (verified owner) –
Critical potentiometer to replace when working on your K4600 monitor. A few of these original pots tested bad after desoldering them.
John (verified owner) –
The black level pot literally disintegrated when I tried to turn it. I got this replacement from arcadepartsandrepair.com and all is well. Thank you for helping to support the community of arcade game collectors.
David Jones (verified owner) –
Thanks for linking this from the K4600 cap kit, it finishes off the chassis rebuild. Won’t have to worry about that monitor for a few decades due to the highest quality parts that were installed.
Tanner Walters (verified owner) –
The kit worked as described. A breeze to install with the right YouTube videos. Will be buying from here again!